Boat Plans & Kits

If you are a designer who offers plans, or kit boats, we invite you to enter your information in the Directory of Boat Plans & Kits. There is no charge! This is for boats of ANY hull material. And if you’re in the market for a boat to build, this is a fine place to start.

 

834 results for All Boat Plans & Kits

9' 6" Nutshell Rowing Kit

Designer: 
Joel White
Skill Level to Build: 
Basic

Our pre-cut kits have been cut by computer-guided routers to provide you with extremely accurate parts. And, the kits come with just about everything needed except the elbow grease.

The ladder frame—the “foundation” of the boat—is...

14' 10" Runabout, RASCAL

Designer: 
Ken Bassett
Skill Level to Build: 
Intermediate to Advanced

A modified V-bottom, with constant deadrise in its after sections. Construction: Plywood and Mahogany over sawn frames. Alternative construction: Cold-molded, double laminated plywood. No lofting is required. Plans include 8 sheets.

Blue Pearl

Designer: 
Timothy F Anders
Skill Level to Build: 
Easy

Are you looking for a small boat that is easy to build and will blow your hair back on the water. Then this stitch and glue 11′ speed boat is for you.

This design has been quarter scale tested and I am starting construction on Serial...

24' 9" Canoe Yawl WENDA

Designer: 
Albert Strange
Skill Level to Build: 
Advanced

A charming, shoal-draft, carvel-planked cruiser for two.

Wenda possesses a timeless elegance.

She’ll work her magic in the 21st century as she did in the 19th.

Construction: Carvel planking over steamed frames.

...

20' 3" Sloop LITTLE GULL

Designer: 
Winthrop Warner
Skill Level to Build: 
Advanced

Round-bottomed pocket cruiser with room for an inboard auxiliary and accommodations for two.

Construction: Carvel planked over steamed frames.

Alternative construction: Cold-molded or strip

Lofting is required.

Plans...

The Open Boat

Designer: 
Jim Flood
Skill Level to Build: 
Very low

This is a design for a basic hull made from one piece of closed cell foam 1m x 4m x 50mm thick. The trade name is Plastazote and there is a distributor in the USA.

The hull can be used to develop a rowing skiff, canoe, kayak or sailing...

Spike Skiff 12' 3"

Designer: 
Iain Oughtred
Skill Level to Build: 
Intermediate

Please note: this design was formerly known as Pike.

Construction - Glue-lap-plywood flat bottom.

Alternative construction - Traditional plank.

No Lofting required.

Plans include 3 sheets with instructions.

Sail...

Fox 16' Sloop LIVELY

Designer: 
Uffa Fox
Skill Level to Build: 
Advanced

Lively, fast, planing racer/daysailer. Construction: Double-diagonal planking over steamed frames. Alternative construction: Cold-molded. Lofting is required. Plans include 4 sheets.