Boat Plans & Kits

If you are a designer who offers plans, or kit boats, we invite you to enter your information in the Directory of Boat Plans & Kits. There is no charge! This is for boats of WOOD hull material. And if you’re in the market for a boat to build, this is a fine place to start.

To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.

 

700 results for All Boat Plans & Kits

ATHELAS

Designer: 
Dave Kuperstein
Skill Level to Build: 
intermediate

Athelas is a 17'-2" open water recreational rower for one or two based on a lines sketch by N. G. Herreshoff. Built from 6 and 9 mm glued lapstrake plywood, she weighs 81 pounds and can be cartopped

THALAS 16'

Designer: 
Paolo Lodigiani
Skill Level to Build: 
beginner

The length of the American Whitehall of the 19th century was between 13′ and 23′. 16′ was the most typical length and the boats were built for 2 or 3 rowers. The classical boat has been re-elaborated to make the design of the boat coherent with...

Half Model Plan SHADOW

Designer: 
N. G. Herreshoff
Skill Level to Build: 
Basic to Intermediate

Compromise sloop designed by N.G. Herreshoff in 1871. The plans produce a model that is 19″ long. When you purchase the set of plans, you also receive instructions on building by the "lift" method, as well as a bit of historical information on...

Auklet 7' 2"

Designer: 
Iain Oughtred
Skill Level to Build: 
Basic to Intermediate

Construction: Glued lapstrake plywood. Alternative construction: Traditional plank, cold-molded and strip planked. No Lofting required. Sail Area : 30 sq. ft. Plan includes 6 sheets.

Wittholz 17' Catboat

Designer: 
Charles Wittholz
Skill Level to Build: 
Intermediate

V-bottomed cruiser designed for plywood construction with accommodations for two and inside ballast.

Construction: Plywood planking over sawn frames.

Lofting is required.

Plans include 11 sheets.

Please note: gaff...

The Open Boat

Designer: 
Jim Flood
Skill Level to Build: 
Very low

This is a design for a basic hull made from one piece of closed cell foam 1m x 4m x 50mm thick. The trade name is Plastazote and there is a distributor in the USA.

The hull can be used to develop a rowing skiff, canoe, kayak or sailing...