Boat Plans & Kits

If you are a designer who offers plans, or kit boats, we invite you to enter your information in the Directory of Boat Plans & Kits. There is no charge! This is for boats of ANY hull material. And if you’re in the market for a boat to build, this is a fine place to start.

 

830 results for All Boat Plans & Kits

14' 10" Outboard SPRITE

Designer: 
Atkin & Co.
Skill Level to Build: 
Basic to Intermediate

An outboard skiff with a wide bottom and moderate rocker that contribute to stability and the ability to carry weight back aft.
Construction: Cross-planked bottom, lapstrake sides

Alternative construction: Plywood or glued-lapstrake...

15' 9" Huron Cruiser

Designer: 
Bear Mountain Boats
Skill Level to Build: 
novice

The lines for this canoe were taken from an original 'Huron' built in cedar/canvas by the Peterborough Canoe Company. It was a second grade model in a series of Cruiser canoes that measured from 16'x33" to 18'x37". "They have good carrying...

Stickleback Canoe

Designer: 
Iain Oughtred
Skill Level to Build: 
Basic

Construction: Glued lapstrake plywood. Alternative construction: Traditional planking, cold molded, strip plank, epoxy-fiberglass. No Lofting required. Plans include 5 sheets.

Alden 21' Double-Ender

Designer: 
John Alden
Skill Level to Build: 
Advanced

A trim, rugged, carvel-planked cruiser with simple accommodations for two and a choice of gaff or marconi rig.

Construction: Carvel planked over steamed frames

Alternative construction: Cold-molded or strip Lofting is required...

Point Comfort 18

Designer: 
Doug Hylan
Skill Level to Build: 
beginner

Here is another little skiff inspired by a Chesapeake Bay working craft. In order to combine chine construction with the kind of bow that can punch into (instead of being punched around by) the Bay’s notorious chop, builders there have long used...

Kalostyn

Designer: 
Andrew Walters
Skill Level to Build: 
beginner

Kalostyn was designed as the subject matter of a book that I had planned to write called, How to design a boat using SketchUp 3D software.

I created a design that had lots of curves in order to demonstrate how to put these...