Boat Plans & Kits

If you are a designer who offers plans, or kit boats, we invite you to enter your information in the Directory of Boat Plans & Kits. There is no charge! This is for boats of WOOD hull material. And if you’re in the market for a boat to build, this is a fine place to start.

To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.

 

696 results for All Boat Plans & Kits

Noank Pulling Boat

Designer: 
Nick Schade
Skill Level to Build: 
Intermediate

The Noank Pulling Boat is an 18′ x 36″ [5.5m x 91cm] sliding seat rowing boat suitable for open water travel. It has two large floatation chambers that can store a massive amount of gear if you should wish to go for an expedition.

This...

Scherzando

Designer: 
Bosco Plana

Scherzando is a 12'10'' open canoe. The construction technique is a wooden basquet whith a canvas skin coated with epoxy or polyester. The plans include 7 station moulds, bow and stem at full escale.

Wynfall

Designer: 
Mark Smaalders
Skill Level to Build: 
moderate

26' Bermudan or gaff-rigged cutter for construction in wood and epoxy

Nymph

Designer: 
Nick Schade
Skill Level to Build: 
easy

Lightweight strip-planked solo double-paddle canoe

Auklet 7' 2"

Designer: 
Iain Oughtred
Skill Level to Build: 
Basic to Intermediate

Construction: Glued lapstrake plywood. Alternative construction: Traditional plank, cold-molded and strip planked. No Lofting required. Sail Area : 30 sq. ft. Plan includes 6 sheets.

BABY BAGGIE

Designer: 
Paolo Lodigiani
Skill Level to Build: 
advanced

BABY BAGGIE is quite long and difficult to build for its size (10 Foot) but has been designed mainly to satisfy the desire of having a small elegant boat.

Kalostyn

Designer: 
Andrew Walters
Skill Level to Build: 
beginner

Kalostyn was designed as the subject matter of a book that I had planned to write called, How to design a boat using SketchUp 3D software.

I created a design that had lots of curves in order to demonstrate how to put these...