Boat Plans & Kits

If you are a designer who offers plans, or kit boats, we invite you to enter your information in the Directory of Boat Plans & Kits. There is no charge! This is for boats of ANY hull material. And if you’re in the market for a boat to build, this is a fine place to start.

 

859 results for All Boat Plans & Kits

Olga 28

Designer: 
Mark Smaalders
Skill Level to Build: 
Moderate

The Olga 28 was designed as a light, relatively fuel efficient cruising boat for the waters around Orcas Island, in the Salish Sea, where the Strait of Juan de Fuca and the Strait of Georgia meet. Strong currents are the norm, and while winds in...

Norwegian Sailing Pram

Designer: 
Simon Watts
Skill Level to Build: 
Intermediate, great for teaching kids

Simon found an older version of this boat back in the eighties and realized that its thousand-year-old design could be copied and preserved without too much difficulty. He measured it out in ’89 and Bill Nielsen lofted it and drew up the plans in...

MicroCatboat

Designer: 
Paolo Lodigiani and Matteo Costa
Skill Level to Build: 
amateur

The design of the boat comes by request of a customer who already owns a Charles W. Wittholz’s catboat and wanted to have a beautiful tender for his yacht. We designed, therefore, a small dinghy of only 2.6 meters with simple and elegant lines,...

Sea Bright 38

Designer: 
Reuel B. Parker
Skill Level to Build: 
Moderate (strip plank) to High (Cold-molded Lapstrake)

Parker Marine Enterprises—Sea Bright 38
Length Over All: 37′ 11”
Beam: 10′ 6″
Draft: 2′ 4″
Displacement: 9,500 lbs, half-laden (approximate)
Power: Yanmar 4JH4HTE (110 hp int/99 hp cont)
Water: 200 gallons
Fuel...

Mill Creek 16

Designer: 
Chesapeake Light Craft
Skill Level to Build: 
Beginner/Intermediate

The Mill Creek 16.5™ is enormously popular because it can be used in so many ways. Not only can you paddle it as a single or a double, but you can sail it, or add a sliding-seat rowing unit.

15' 9" Huron Cruiser

Designer: 
Bear Mountain Boats
Skill Level to Build: 
novice

The lines for this canoe were taken from an original 'Huron' built in cedar/canvas by the Peterborough Canoe Company. It was a second grade model in a series of Cruiser canoes that measured from 16'x33" to 18'x37". "They have good carrying...

The Open Boat

Designer: 
Jim Flood
Skill Level to Build: 
Very low

This is a design for a basic hull made from one piece of closed cell foam 1m x 4m x 50mm thick. The trade name is Plastazote and there is a distributor in the USA.

The hull can be used to develop a rowing skiff, canoe, kayak or sailing...