Boat Plans & Kits

If you are a designer who offers plans, or kit boats, we invite you to enter your information in the Directory of Boat Plans & Kits. There is no charge! This is for boats of ANY hull material. And if you’re in the market for a boat to build, this is a fine place to start.

 

835 results for All Boat Plans & Kits

VOYAGER DS 655

Designer: 
BRUCE ROBERTS-GOODSON
Skill Level to Build: 

VOYAGER DS 655 WOOD / EPOXY, Fiberglass or Steel.

The cockpit extends from inside the 'dog house' with 5 ft sitting headroom though to near the transom as shown. Engine is under the dog house.

Elf

Designer: 
Iain Oughtred
Skill Level to Build: 
Intermediate to Advanced

Construction - Glued lapstrake clinker plywood.

No Lofting required.

Plans include 8 sheets with photocopies of Classic Boat building series.

Sail Area - 53 sq. ft.

ROBERTS 39 POWER SAILER

Designer: 
BRUCE ROBERTS-GOODSON
Skill Level to Build: 

These catamarans were designed to be built using the fibreglass panel construction techniques. The method is very simple to use and perfect for the inexperienced builder. All of the developing is done

Blue Pearl

Designer: 
Timothy F Anders
Skill Level to Build: 
Easy

Are you looking for a small boat that is easy to build and will blow your hair back on the water. Then this stitch and glue 11′ speed boat is for you.

This design has been quarter scale tested and I am starting construction on Serial...

Sandy

Designer: 
Mark Smaalders
Skill Level to Build: 
Moderate

Sandy was designed for extended coastal cruising in such areas as the east coasts of the U.S. or Australia, the Pacific Northwest, or Europe. Conditions in coastal waters can vary enormously, and include a range of conditions including storms,...

18' Catboat

Designer: 
Fenwick Williams
Skill Level to Build: 
Advanced

Construction: Carvel planked over sawn & steamed frames. Alternative construction: Cold-molded or strip. Lofting is required. Plans include 11 sheets.

Half Model Plan MINERVA

Designer: 
William Fife, Jr.
Skill Level to Build: 
Basic to Intermediate

Cutter designed by William Fife Jr., in 1888.

The plans produce a model that is 28″ in length.

You’ll receive 3 pages of plans historical information about the boat, step-by-step instructions and full-sized patterns for each lift...