Boat Plans & Kits

If you are a designer who offers plans, or kit boats, we invite you to enter your information in the Directory of Boat Plans & Kits. There is no charge! This is for boats of ANY hull material. And if you’re in the market for a boat to build, this is a fine place to start.

 

835 results for All Boat Plans & Kits

Pulling Boat, LIZ

Designer: 
Ken Bassett
Skill Level to Build: 
Advanced

Elegant, high-performance, sliding-seat pulling boat designed to mitigate the speed-robbing pitching associated with some sliding-seat craft.
Construction: Lapstrake planked over steamed frames.
Alternative construction: Cold-molded,...

ROBERTS 39 POWER SAILER

Designer: 
BRUCE ROBERTS-GOODSON
Skill Level to Build: 

These catamarans were designed to be built using the fibreglass panel construction techniques. The method is very simple to use and perfect for the inexperienced builder. All of the developing is done

Half Model Plan MINERVA

Designer: 
William Fife, Jr.
Skill Level to Build: 
Basic to Intermediate

Cutter designed by William Fife Jr., in 1888.

The plans produce a model that is 28″ in length.

You’ll receive 3 pages of plans historical information about the boat, step-by-step instructions and full-sized patterns for each lift...

Point Comfort 23

Designer: 
Doug Hylan
Skill Level to Build: 
intermediate

This boat is a larger version of my popular POINT COMFORT 18, a traditional Chesapeake Bay workboat type reinterpreted for simpler and more modern construction. Like her smaller sister, this design is drawn to use plywood – in large pieces where...

RoofRack

Designer: 
John Welsford
Skill Level to Build: 
Beginner

A small and very simple tender to fit inside a station wagon or on a roofrack, this little plywood dink will suit some one wanting a tender for their small yacht or motorboat.

Kalostyn

Designer: 
Andrew Walters
Skill Level to Build: 
beginner

Kalostyn was designed as the subject matter of a book that I had planned to write called, How to design a boat using SketchUp 3D software.

I created a design that had lots of curves in order to demonstrate how to put these...