Boat Plans & Kits

If you are a designer who offers plans, or kit boats, we invite you to enter your information in the Directory of Boat Plans & Kits. There is no charge! This is for boats of ANY hull material. And if you’re in the market for a boat to build, this is a fine place to start.

 

845 results for All Boat Plans & Kits

PUCK 550

Designer: 
Paolo Lodigiani
Skill Level to Build: 
intermediate

The PUCK reflects the spirit of the original class which was to create a boat used in regattas but also suitable for coastal cruising, easy to carry and inexpensive.
All of these features are found in PUCK, a boat comfortable and stable,...

20' Maid of Endor

Designer: 
John Atkin
Skill Level to Build: 
Advanced

This 20′ cutter will prove challenging to build, but will reward your efforts with incomparable charm and grace.

Atkin specifies traditional plank-on-frame construction.

Construction: Carvel-planked over steamed frames.

...

16' Gentleman's Runabout

Designer: 
Nelson Zimmer & John Hacker
Skill Level to Build: 
Advanced

A low-power, moderate-speed inboard runabout for protected waters. Designed for sawn frames and batten-seam planking.

Construction: Battened-seam planking over sawn frames. Lofting required. Plans include 5 sheets.

Please note:...

18' Single Shell FIREFLY

Designer: 
Ken Bassett
Skill Level to Build: 
Basic to Intermediate

An entry-level sliding-seat pulling boat. Provides rewarding speed in an easily built hull with enough stability to keep a beginner out of trouble. Construction: Plywood. No lofting is required. Plans include 5 sheets.

International 110

Designer: 
C Raymond Hunt
Skill Level to Build: 
intermediate

The plans and construction manual for the plywood International 110 are available to any class member for use to build new or rebuild and restore an older boat.

Noank Pulling Boat

Designer: 
Nick Schade
Skill Level to Build: 
Intermediate

The Noank Pulling Boat is an 18′ x 36″ [5.5m x 91cm] sliding seat rowing boat suitable for open water travel. It has two large floatation chambers that can store a massive amount of gear if you should wish to go for an expedition.

This...

Half Model Plan MADGE

Designer: 
George L. Watson
Skill Level to Build: 
Basic to Intermediate

British plank-on-edge cutter designed by George L. Watson in 1879.

The plans produce a model that is 23″ long.

You’ll receive 3 pages of plans historical information about the boat and step-by-step instructions and full-sized...