View Full Version : Building / Repair
- Flat paint
- What wood to use for mast repair?
- Lapstrake Replacement
- Two or three laminations for my gaff and boom?
- Mast hoops... Too big?
- hardware re-finishing
- Plank width
- lifespan of a wood-epoxy boat
- Plywood Knees
- brush or roll?
- Wooden deck
- Treat panks: Now or Later?
- Glue Sticks
- plating prep
- Buster
- Q? on Penobscot 14
- Plywood $
- Miniwax water based stain
- Tricks of the Trade.....Workbench
- Paint Removal - truck bed paint
- Carvel Restoration
- More construction pics
- decks,why this winter project?
- Outboard motor steering for Center Console
- Mast Hoops
- Ice protection on wooden boat???
- 1949 Classic Rhodes Yawl, "PAVANA"
- Finally Finished......Pictures
- source for silicon bronze staples
- Final outrigger shape
- Looking for Boatwright work in Wisconsin
- black locust & honey locust
- Planking in need of gutter hand plane to fit near bilge
- Interlux Seam Compund alternatives?
- Use of Liquid Nails in Boat Building
- Ply Soup
- Kayak progress
- Folkboat restoration
- Adding complication: sail track
- Runabout construction
- GE vs. Leeson Bandsaw Motors
- The "RIGHT" finish for caned seat thwarts HELP!!!
- lining masthead sheave with copper
- Bad plywood- End of story (at least this chapter)
- 5-ply 1/4"birch
- Wood Identification Site
- M/B Dreggen - 47' Renovation project - new pics
- Sacrificial bottoms
- Help 5200 in seams
- Getting ready for another coat of Kirby's(pic)
- Coins at base of mast
- Traditions
- Keel rabbet done - on to the transom
- lap lands (Grey Seal)
- U-Bolt Bow Eye Installation
- boatbuilders block
- sealing a hull
- using Wana for Planking
- hardware re-finishing
- Monterey pine (Pinus radiata) Plywood in Boat Building
- Two dumb questions
- keelson length?
- centreboard slot servicing
- Glass-bottomed boat pics+coved coaming
- L.F.H.
- Boat building web sites moved
- Floors (in houses, not boats)
- bungs into funky countersinks
- restoration needs grant
- Rubrails
- Boat status with pictures
- Black Cherry for Small Craft Backbone?
- Filling the gaps on mahogany hulls
- stormsvala research
- Need help w/an old 1961 Chris Craft Refrigerator
- SV Pavana Back on the Market
- Removing rust stain from sail?
- Devlin Dipper a building Cool Site
- Cutting a rabbet in Keel of Catspaw Dinghy
- Concrete ballast/freeze over time?
- bending plywood
- Sikkens over CPES on teak toe rail??
- Drillpress grinding/sharpening jig.
- suggestions for first wooden boat building project?
- Building Oughtred's Acorn Dinghy
- Wooden Boat Builder in Texas
- sources for yellow cedar and clamp handles?
- Brain teaser for ya - how was this done?
- electrical black magic
- Row Boat Design
- lofting question (24' lyle hess cutter)
- Varnish, Again!
- Mahogany jackpot!
- 1926 burger schooner in need of a home
- Project update photos
- Golant Gaffer build - rigging
- 1910 Crosby cat on eBay
- Golant Gaffer building
- Dave Fleming was right (of course)
- Seeking Info on 1919 Blanchard/Geary
- Salt water in the bilge
- WANTED.......Marine Straight Eight
- Centerboard
- Cold and heat gun
- To hull or not to hull?
- catspaw planking
- Rudder and skeg repair w/ epoxy
- Marine Silicone rubber question
- Further harpin musings...
- stormsvala hull repair options
- Ring frames in trad. construction?
- Leak in my bow.....
- Wooden Runabout Restoration Book
- Power requirements
- Kayak construction question
- cotton canvas sails
- epoxy safety
- Bending Ash vs Bending Plywood
- Green Planking Stock Question
- Keel Bolts
- Teak Deck
- Transom Plywood Question
- Herreschoff 28' (not H28'?
- Calling Oyster
- Raft up on the Chesapeake?
- Some Boat Pics.....
- Runabout construction material
- Plan to build a 40+ ft sloop, but never build a boat before...
- Ipe lumber
- progress pics and question
- Missing Parts
- Thole pins, anybody made them?
- Fun in the bilge
- Cutter to Schooner to Yawl
- Catspaw Station molds
- Progess report
- Perplexed by blocks and fittings
- Rechrome service
- dovetail jigs
- Half built boat protection
- how may coats of CPES
- Buffing equipment
- Tapered battens
- Wooden Boat terms
- Wire splicing vise?
- Minor progress update
- Wood Hull Repair
- rot around fasterners
- Fiberglass and Silane vs Volan finishes
- I hate painting
- System 3 or West??? I Can't Decide...
- Elm for bent frames?
- Elm for bent frames?
- Washer clearance in counterbores
- who's gotta sliding mitre saw
- New Wooden Boat owner, lots of questions, Sea Tigersand gretings from The Netherlands
- Finish Carpentry Question
- 283 Chris-Craft 1959
- Oil vs. Varnish
- Headin Home
- What size rigging?
- water ski plans?
- James Lawrence Sailmakers
- Home Wrecker
- 1930 Jonesporter Progress & Pics
- Chris and the Schooner Etain??
- A Question regarding CPES
- engine no 1
- Using a Screw for a Small Leak
- More European runabout pics
- Interior Wood and Fiberglass Paint
- Advice on silicone application
- woodenboats 20'utility launch
- re-chroming and hardware restoration
- MR-10 Lexan - scratch/solvent resistant plastic
- spring fever (pics): can't wait to go sailing
- Airless netherparts
- ipe spreaders
- Chine bolts
- Plaster ceiling demolition
- A question for the big drum of epoxy users!
- Rig Problem
- Never used a rotary hammer.
- choice of timber for a new deck
- How does one lash?
- Frame repair question (link to photos)
- Rudder Lock Down on Smaller Sail Boats
- Monel or Stainless?
- 12 volt bulbs in 110 fixtures?
- Broken chine bolts
- Gold Leaf Name on Transom
- another lofting question
- Table Saws Again
- A Workmanship rant
- Need help on stuffing boxes/bearings
- Tongue and groove bulkheads
- Hartley 24 Build
- Bilge Cleaner
- Salt vs. fresh in the bilge
- Stopwater Material
- Bacteria
- how much can a small boat take?
- Status Check - 23 Feb 03
- row lock supposrt blocks
- Solid wood floors: green or dried?
- East Coast CPES
- A tiller for the Dark Harbor... Best wood to use?
- Rift or Quarter Sawn Strip question
- Motorized Canoe "Charlotte"
- Lofting Paper?
- Old blocks (that need help)
- Advise on hauling out
- Creating a builders plate
- Schooner porn
- O&O East Progress Report Please?
- Ice Dams
- re-doing seams...looking for advice...
- centerboard ballast
- progress pics on shop(no boat progress)
- Building a scale model
- Floorboards
- ipe
- ipe
- Workplace lust...
- Building Grace O'Malley
- Progress pics, as promised ;)
- Glue lines and strength
- Temporary keel
- Small Boat Bailers
- deadeye bands
- Art Read.......
- Laying out bevels on frames
- Varnishing in the Cold
- Hollow Mast Building
- solvent for varnish drips?
- self tending jib
- Nice Chebacco
- more Bart construction pics update
- polishing bronze
- CPES Over Varnish
- OK, That's It
- bedding compound drying time?
- finishing bronze centerboard
- Minwax Liquid Wood Hardener
- Engines, pumps and money
- Wooden Lightning Sailboat
- PIRATE splashed...film at eleven!
- It's Warming Up!!!
- Winch Installation Advice
- Lightning Transom Repair
vBulletin® v3.7.2, Copyright ©2000-2009, Jelsoft Enterprises Ltd.