- Acorn 15 Finished
- Hi - Introducing myself.
- Millilitres per microfortnight?
- Practical and safe limits for trailering
- Mounting jib sheet T-track
- Keel pivot material and boom question - K boat
- Planking Stock
- 1963 36ft wooden sailboat project - $6000 (South Seattle)
- Problems with Roll and Tip 2 Pack Hull Paint
- Silicon Bronze screws 12# x 2" in Sydney
- Epoxy and wooden boats
- Wailana - 40" pilot house cutter
- Can a plank scarphed with epoxy be steamed
- Scarfing white oak keelson
- first (almost) sail
- Lower cost boat construction
- Oughtred Skua Launch
- bright finish on spars that aren't "perfect"
- 1930s Lapstrake Dinghy Restoration
- Boat plumbing fitting rant
- My garage is made of boat parts!
- Sharpie construction
- Coracle
- Tackling a Bluejay
- Have you all seen this?
- Pintle Problems
- Help! - One hour boatbuilding workshop
- Boat Turning
- Free Swedish Racing Sloop - Bay Area
- mini tugboat
- Info wanted....Chechen
- molding latigo leather around the yard yoke
- Wood for stem and keel
- "Martha's Dingy"
- Mast Refinishing "101": Classroom Is Open; Teachers Invited
- 1964 Thompson Sportsmen
- Western White Pine?
- Pin Rail Construction
- Greenhart wood poisonous
- Penguin Skeg Lenth
- Your thoughts required
- traditional stem- glue or goo?
- Slightly different stripping
- Someone please explain
- Rangeley mold
- Grey seal Rolled Over
- Removing tar oder from bilge
- Replacing Iron Floors
- Bilge buildup & pumps
- Swedish Renovation Project; Help?
- Geodesic Airolite Classic 12
- Glueing with epoxy
- Cypress
- how to proceed roof repair?
- aerolite? glue
- Will this work?
- Winterizing the bottom
- Resorcinol scarfs
- 1948 Taylor cabin cruiser
- More Common Sense Sloop Photos
- 42"of Fury
- Rare Find-Sailboat Parts
- dory planking pics
- Size/dimensions for wood cleats?
- HD Pine?
- strip planks OK without fiberglass sheath?
- Introducing Maddie-a Marisol skiff
- Deck leak solution
- John Gardner's "Pram of Surprising Ability"
- Anyone want a Poulsbo Boat?
- Glueing veneers
- Greetings - Sealant for screws
- Wright-Built K boat float? - not so much - help pics
- problem with rudder
- Anyone tried "All Fair" by US Paint?
- Deck Camber
- Anybody have any idea what this is...
- A stern cover...
- Block ID
- Any others out there that have a Culler 18'6" good little skiff?
- Didn't know where to put this
- Boom Gallows location
- Help with repair of soft cabin side section
- carbon fiber and cold molding
- Best brush for epoxy
- Physics of a leaky boat
- New Simmons 18 Launched
- Blackberry Launch
- So much for keeping the canvas...
- Sumner-8 info and help?
- Ike and repairs have slowed me down
- Long Board
- New to lofting
- frame material for traditional carvel construction
- How to countersink for a carriage bolt?
- Quercus douglasii as a boatbuilding wood
- Frugal Skiff
- Installing a bottom
- Caledonia yawl
- Oysterman 16' Cutter
- Rebedding...
- Splash - Thanks to everyone!!! Sailing pics
- Which gouge for La Boheme?
- Scrap Lead Keel?
- folkboat engine??
- Weight of lead, size of a gallon
- Stitch and Glue
- Should boat parts be stabilized with a coat of epoxy or resorcinol?
- Looking for info on a Carter 16
- Good tool/bad tool
- Al spars
- Rigging
- Plastic Frames
- Hollywood Boat Emblem
- Aluminum Centerboard
- gaff rig backstays
- Finally ordering good oarlocks
- Ben Garvey Planking
- Vire installation
- What Do I Do With
- interior color choices for Good Little Skiff
- Advice for cutting up a lead keel.
- BUILDING another yacht
- Hollow Spars
- Building & Launch of Hornpipe, a Kurylko “Alaska”
- Ribbands : wood and scantling
- The wood-finish round-table thread
- chapelle sharpie white pine planking?
- Inspirational Photos - 1964 Thompson Sportsmen
- Whiskey plank today!
- How big is your torture board?
- Blue Moon S/Y Tayo-Mar
- Masts are down... now what!
- Edwin Monks Hornet
- Bridge Deck Hatch restoration question
- Fastening planking to framing :: how to?
- wood boring beasty
- Building a Boat Gantry
- saltwater vs fresh
- Pitch - Up close and personal
- Folkboat dilemma
- Bronze Rod as Rivets
- OK...Which one?
- Why use epoxy filler ?
- Glued lapstrake vs strip
- Keel batten - Lumberyard Skiff
- epoxy plugs
- pine/epoxy
- Bedding Compound?
- Which One?
- Teak and cedar for Oars?
- Charlotte Canoe
- Vaccuum Kilns
- Party who PMed me...
- Ash vs. Hickory
- tandem rowing configuration
- pointing tips w/ a sprit rig
- powercat
- bilging: how much is too much?
- How to wrap an oar?
- Complete Varnish and Bronze hardware on Wherry
- Thimble size for 12mm (1/2") Galvanized wire rope
- Flow diagram for San Juan heat exchanger?
- Ken Bassett's "Liz"
- filleting insides of Grey Seal
- Engine alignment/vibration
- Lead keel / Mahogany plank joint reapir
- Boat Value?
- Big mistake? pine planks-please help
- Shellback Dingy/Epoxy
- Atlantic white-cedar
- I give up!
- Mast Shape when using Mast Hoops
- Fillers for Re-Canvasing a Canoe
- Herreshoff
- Rascal Pics - almost done
- Help needed with chine to stem
- Dingy Photos
- zinc, brass, German silver, not stainless steel...
- Transom Too High for Outboard
- SABB Advice - electrolysis problems with the variable pitch propeller?
- Painting
- Dinghy Connections
- Splash
- Fresh water or salt
- Mast Damage
- Stem for whisp
- winch handle repair
- wood mast repair
- Anyone built a Devlin Seaswift?
- Status of things
- Glassing (fiberglass + epoxy?) - clarity, technique...
- Stove question
- Strip built Eel
- garborboard fitting
- tiller construction
- Buzzards Bay 14 Progress Photos 10-25-08
- Tugboat
- Steelframed wooden hull
- Day Dream Finished
- launched Bolger Sea Hawk last weekend
- Decking for Bolger Singlehanded schooner
- Buying a Boat: Sight Unseen!
- On Golden Pond
- How much damage can you do to a H28 in 3 to 4 minutes?
- what to add to clear epoxy to make it black?
- MacGregor Canoe Blog - and another build starts
- strip building
- Plywood scarf clamping suggestions
- Old Town Skiff Project
- Better Battens
- I'm back
- Variable angle clamp
- Good Idea/Bad Idea??
- Will epoxy react with tar on ballast keel?
- First boat
- building a boat
- Lumberyard Skiff with Keel, Mast and rudder
- advice on mirror dinghy repair
- Canvas Cabin Top
- Fasteners for a plywood boat
- Peel away paint stripper
- Another paint question!
- Worm,parcel and serve supplies
- Redwood Mast
- new project/new memeber
- looking for plywood
- How2make Polyester stick to plywood...
- Finally got to updating my Coquina website
- The Mother of All Maritime Links
- Storm sail
- I tried eye splicing double braid
- Michalak AF3 Launch
- A little keel work in progress
- Anybody know about New Zealand pine?
- Joel White bangor Packet 20' rowing skiff
- wooden sailboat on craigslist
- oars of poplar
- Dave Carnell on Acrylic Latex for small boats
- Wood in California
- Launched it!
- Beetle Cat
- oar material?
- Identifying El Piso?
- Skeg wood choice
- Whaler "Charles Morgan" drydocked for repairs
- Gluing chines
- Canoe Paddle Repair
- 18' 6" redwing
- Folkboat Fit-out