Bronze stock for tangs

[Carlsboats]

Where would I go to buy bronze plate stock for shroud tangs and for mast fittings? Will need
only a small quantity of stock about 1/8" thick, widths to 2-3 inches, and lengths of 24 inches and less. Silicon bronze would be okay, but suspect it would be easier to saw/shape Tobin,
and that should be strong enough.

[Carlsboats]

Where would I go to buy bronze plate stock for shroud tangs and for mast fittings? Will need
only a small quantity of stock about 1/8" thick, widths to 2-3 inches, and lengths of 24 inches and less. Silicon bronze would be okay, but suspect it would be easier to saw/shape Tobin,
and that should be strong enough.

[Carlsboats]

Where would I go to buy bronze plate stock for shroud tangs and for mast fittings? Will need
only a small quantity of stock about 1/8" thick, widths to 2-3 inches, and lengths of 24 inches and less. Silicon bronze would be okay, but suspect it would be easier to saw/shape Tobin,
and that should be strong enough.

[Donn]

Try these guys. (http://www.anchorbronze.com/)

[Donn]

Try these guys. (http://www.anchorbronze.com/)

[Donn]

Try these guys. (http://www.anchorbronze.com/)

[Rosebud]

Try these people:

www.atlasmetal.com (http://www.atlasmetal.com)

Good luck. We've had good luck with them.

Jim and Kim

[Rosebud]

Try these people:

www.atlasmetal.com (http://www.atlasmetal.com)

Good luck. We've had good luck with them.

Jim and Kim

[Rosebud]

Try these people:

www.atlasmetal.com (http://www.atlasmetal.com)

Good luck. We've had good luck with them.

Jim and Kim