PDA

View Full Version : stemhead fitting

yeatsfreak
07-09-2005, 09:57 PM
I broke my stemhead fitting and don't know where to get a new one:

http://june23rd.com/persuasion/yard/furler.jpg

I tried Spartan Marine, Bristol Bronze, and every chandlery that came up on the internet. All to no avail.

The part goes on a SouthCoast 23, yes it is plastic, but it is 40 years old and has all bronze hardware. It's a beauty.

Thanks for the help,
Jarrett
yeatsfreak
07-09-2005, 09:57 PM
I broke my stemhead fitting and don't know where to get a new one:

http://june23rd.com/persuasion/yard/furler.jpg

I tried Spartan Marine, Bristol Bronze, and every chandlery that came up on the internet. All to no avail.

The part goes on a SouthCoast 23, yes it is plastic, but it is 40 years old and has all bronze hardware. It's a beauty.

Thanks for the help,
Jarrett
yeatsfreak
07-09-2005, 09:57 PM
I broke my stemhead fitting and don't know where to get a new one:

http://june23rd.com/persuasion/yard/furler.jpg

I tried Spartan Marine, Bristol Bronze, and every chandlery that came up on the internet. All to no avail.

The part goes on a SouthCoast 23, yes it is plastic, but it is 40 years old and has all bronze hardware. It's a beauty.

Thanks for the help,
Jarrett
Bob Smalser
07-09-2005, 10:16 PM
Ebay Motors boat parts.

I've seen half a dozen in bronze in as many months. Am sure there were more in SS I didn't look for.
Bob Smalser
07-09-2005, 10:16 PM
Ebay Motors boat parts.

I've seen half a dozen in bronze in as many months. Am sure there were more in SS I didn't look for.
Bob Smalser
07-09-2005, 10:16 PM
Ebay Motors boat parts.

I've seen half a dozen in bronze in as many months. Am sure there were more in SS I didn't look for.
rbgarr
07-09-2005, 10:30 PM
You might try contacting Richard Remson, a foundry owner in West Rockport, Maine. He may be able to make a new one for you if you send the old parts (?)

Have you tried looking for a South Coast class association website or bulletin board?
rbgarr
07-09-2005, 10:30 PM
You might try contacting Richard Remson, a foundry owner in West Rockport, Maine. He may be able to make a new one for you if you send the old parts (?)

Have you tried looking for a South Coast class association website or bulletin board?
rbgarr
07-09-2005, 10:30 PM
You might try contacting Richard Remson, a foundry owner in West Rockport, Maine. He may be able to make a new one for you if you send the old parts (?)

Have you tried looking for a South Coast class association website or bulletin board?