JeffH
01-27-2003, 08:31 PM
Yep, time once again to unload some of the accumulation on my hard drive. This is, for those just joining, the Alden-designed schooner 'Heron' in Camden, ME.
http://www.imagestation.com/picture/sraid48/pd906f15cf442db10d615e1df66a5d509/fcb83a82.jpg
The major accomplishment of the weeks was that we are done planking! Woohooo! Well, not quite... There are two more strakes left to go, including the sheer strake, but those will be left off until the sheer clamps and beam shelves are in.
http://www.imagestation.com/picture/sraid48/pcfff195fac080ef09e83f0c4ef5070cb/fcb83a84.jpg
Nice to see her looking like a boat, finally. Sadly, these pictures lose a little in shrinkage. Originally, they were about 1.5 meg each, which was a bit more than my poor dial-up could handle. You get the drift, though..
http://www.imagestation.com/picture/sraid48/p531af0ac39b2c35a1ecb97c8918ca1fd/fcb83a79.jpg
Well yes, a mite bit of twist there. Went in without steaming, though just barely. The aft ends of the sheer clamps will be steamed, since 2 5/8" by 6" angelique doesn't bend too well. I'll post photos of those when they go in.
'Till then,
Jeff
http://www.imagestation.com/picture/sraid48/pd906f15cf442db10d615e1df66a5d509/fcb83a82.jpg
The major accomplishment of the weeks was that we are done planking! Woohooo! Well, not quite... There are two more strakes left to go, including the sheer strake, but those will be left off until the sheer clamps and beam shelves are in.
http://www.imagestation.com/picture/sraid48/pcfff195fac080ef09e83f0c4ef5070cb/fcb83a84.jpg
Nice to see her looking like a boat, finally. Sadly, these pictures lose a little in shrinkage. Originally, they were about 1.5 meg each, which was a bit more than my poor dial-up could handle. You get the drift, though..
http://www.imagestation.com/picture/sraid48/p531af0ac39b2c35a1ecb97c8918ca1fd/fcb83a79.jpg
Well yes, a mite bit of twist there. Went in without steaming, though just barely. The aft ends of the sheer clamps will be steamed, since 2 5/8" by 6" angelique doesn't bend too well. I'll post photos of those when they go in.
'Till then,
Jeff