mdo plywood delamination

[kulas44]

I have some large mdo ply panels just below the sheer and above the topmost mahogany plank. There are some areas of delamination on them, mostly at the edges. They would be very difficult and time consumeing to change. Can they be reglued. I really don't want to pull them off. Maybe epoxy injection and screws, verneers, I'm open to any suggestions, thanks.

[John Blazy]

Its important to make sure the areas are dry, but epoxy injection through a plastic syringe through drilled holes is the best trick around. Drug stores might even carry the "irrigation" type syringes that have the curved tips - easy for access to holes. Use a hot melt glue gun to seal the holes after the epoxy is injected, or use filler putty.

Do not try to inject through needles - too small for high viscosity epoxy.