If you’re in the market for a boat to build, this directory of Boat Plans & Kits is a fine place to start. And if your company sells plans or kits, we invite you to list your offerings here. There is no charge for listing, but the FEATURED BOATS MUST BE BUILT OF WOOD.
To refine your search of this directory, use quotation marks. If you search Nutshell Pram Kit, you’ll receive all the listings that include the words Nutshell, Pram, and Kit. To refine your search, enter “Nutshell Pram Kit”; you’ll then see only the results for Nutshell Pram kits.
To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.
This is a design for a basic hull made from one piece of closed cell foam 1m x 4m x 50mm thick.
V-bottomed cruiser designed for plywood construction with accommodations for two and inside ballast.Construction: Plywood planking over sawn frames.Lofting is required.Plans include 11 sheets.Please note: gaff rig version’s mast measurements are taken by scaling from the plans.Notice the below de
The Sail kit allows you to transform the canoes NINFA, NAIADE and ONDINA, in small sailing trimarans for coastal cruising with minimal efforts.
‘Volare’ comes in two versions. This is the console version, the utility version is available as a separate set of plans. They’re both 15′4″ long and 5′ wide.Her length is that of two sheets of 8′ plywood and she’s built in two halves (bow end and stern end).
The PT skiff is a very fuel efficient center console runabout that is good looking, has good handling, can carry a load, and is incredibly quick with only 20 horsepower.
Athelas is a 17'-2" open water recreational rower for one or two based on a lines sketch by N. G. Herreshoff. Built from 6 and 9 mm glued lapstrake plywood, she weighs 81 pounds and can be cartopped
This schooner is intended as a comfortable cruising yacht for a couple with occasional guests, and to be of simple construction so that Jack everyman can build it. It has a twin keel / centreline rudder configuration.
PALOMA is a simple, traditional and versatile boat which has been designed in three versions, as a small cruiser, as an open daysailer and as a motorboat.
Our pre-cut kits have been cut by computer-guided routers to provide you with extremely accurate parts. And, the kits come with just about everything needed except the elbow grease.The ladder frame—the “foundation” of the boat—is included with the kit.
The ballast keel wooden sloop "Rascal" was donated in 2021.
19' Lightening sailboat (hull #4444). Cedar plank hull restored.
2018 Dark Harbor 17 1/2 constructed western red cedar planking on white oak frames., Teak deck.
