Sailboats - Cruising
18' Catboat
Construction: Carvel planked over sawn & steamed frames. Alternative construction: Cold-molded or strip. Lofting is required. Plans include 11 sheets.
If you’re in the market for a boat to build, this directory of Boat Plans & Kits is a fine place to start. And if your company sells plans or kits, we invite you to list your offerings here. There is no charge for listing, but the featured boats must be built of wood. To refine your search of this directory, use quotation marks. If you search Nutshell Pram Kit, you’ll receive all the listings that include the words Nutshell, Pram, and Kit. To refine your search, enter “Nutshell Pram Kit”; you’ll then see only the results for Nutshell Pram kits.
To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.
Construction: Carvel planked over sawn & steamed frames. Alternative construction: Cold-molded or strip. Lofting is required. Plans include 11 sheets.
Elegant, high-performance, sliding-seat pulling boat designed to mitigate the speed-robbing pitching associated with some sliding-seat craft.
Construction: Lapstrake planked over steamed frames.
Alternative construction: Cold-molded, strip or glued lapstrake.
Simon found an older version of this boat back in the eighties and realized that its thousand-year-old design could be copied and preserved without too much difficulty. He measured it out in ’89 and Bill Nielsen lofted it and drew up the plans in ’91.
Safe, dry, fast, and seaworthy V-bottomed inboard powerboat designed for carvel planking.
Construction: Carvel planked over sawn frames.
Alternative construction: Strip
Lofting is required.
Propulsion: 6 cylinder 350 cubic inboard.
Plans include 6 sheets.
Based on Tom Gillmer and Iver Franzen’s New Moon (an enlargement on Gillmer’s Blue Moon), this sailing vessel is intended to be a stout, seaworthy, offshore-capable passagemaker, with an emphasis on the balance between comfortable sea-keeping and good sailing abilities.
“Breeze” is a 10′ (3m) double paddle canoe. Two sheets of plywood needed. Stitch and glue construction using 3″(75mm) fiberglass tape in epoxy for all seams inside and out. The deciding factors when designing the boat were mostly the same as with all my designs - seaworthiness and lightweight.
Complete with spars and sails. Lying Cape Cod. Last restored c1970. Cockpit and deck are newer.
Lord Nelson Royal Navy 1798 pattern Pinnace. Pine on oak. Length 28.5 feet. Needs few repairs.