Sailboats - Cruising
Goat Island Skiff
The Goat has become known worldwide for being a simple to build and simple to sail that delivers.
If you’re in the market for a boat to build, this directory of Boat Plans & Kits is a fine place to start. And if your company sells plans or kits, we invite you to list your offerings here. There is no charge for listing, but the featured boats must be built of wood. To refine your search of this directory, use quotation marks. If you search Nutshell Pram Kit, you’ll receive all the listings that include the words Nutshell, Pram, and Kit. To refine your search, enter “Nutshell Pram Kit”; you’ll then see only the results for Nutshell Pram kits.
To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.
The Goat has become known worldwide for being a simple to build and simple to sail that delivers.
The CS-18 is an open interior design with the home builder in mind. It is designed for an above deck fuel tank and less aggressive flare in the bow. These features make this design an easier and faster build and at 18.5′, it will fit in most home garages.
The cradle boat Baby Tender is an adaptation of the classic yacht tender carried aboard many of the finest yachts during the time when wooden boatbuilding was truly an art. The boat has a length of 45 in. and a beam of 22 in.
This exquisite launch leaves little wake at five knots. Her plans show both cold-molded and plank-on-frame construction. Construction: Cold-Molded or Carvel planked over steamed frames. Alternative construction: Lapstrake. Lofting is required. Plans include 5 sheets.
The Crystal 16 was designed to be a simple, lightweight flats skiff. Her hull is a simple V-bottom with a bit of flare in her topsides. Her deck features a large casting platform forward with two smaller platforms back aft on both sides. Storage is available up forward below the casting deck.
“Breeze” is a 10′ (3m) double paddle canoe. Two sheets of plywood needed. Stitch and glue construction using 3″(75mm) fiberglass tape in epoxy for all seams inside and out. The deciding factors when designing the boat were mostly the same as with all my designs - seaworthiness and lightweight.
Lapstrake-plywood daysailer with a shapely wineglass transom, unstayed sprit rig, and wide, flat, keels for easy trailering.
Construction: Lapstrake plywood planking over steam bent frames.
Alternative construction: Cold-molded or strip.
No lofting is required.
M80, is a simple to build plywood trailable trimaran, plans are very complete and include DXF files for CNC cutting.A standard folding system is used to faciltate trailing by road at a folded width of 2450mm.The interior consists of two wing berths 2000 x 600 a single up forward 1900 x 700 with r
Traditional "Whitehall" elegance in a stitch-and-glue kit. For casual single and tandem rowing, we do not believe there is a better build-your-own-boat kit than the Chester Yawl.
The Hiawatha is a general purpose recreational canoe of light displacement, designed in the tradition of contemporary American cruisers. A good solo canoe, it is also very fast and responsive.
Custom hand-made cedar strip/epoxy freight canoe, 18' with square stern.
Launched 2022, WoodenBoat Show winner, sail or row, Atlantic white cedar hull, kick up rudder, sp
Complete with spars and sails. Lying Cape Cod. Last restored c1970. Cockpit and deck are newer.