Motorboats - Outboard
Macomber 15
The Macomber 15 is a traditionally built flat bottom Westport River Skiff.
LOA: 15'2"
Beam: 5'11"
Draft: 6"
Max Hp: 25 (15Hp.recomended)
If you’re in the market for a boat to build, this directory of Boat Plans & Kits is a fine place to start. And if your company sells plans or kits, we invite you to list your offerings here. There is no charge for listing, but the featured boats must be built of wood. To refine your search of this directory, use quotation marks. If you search Nutshell Pram Kit, you’ll receive all the listings that include the words Nutshell, Pram, and Kit. To refine your search, enter “Nutshell Pram Kit”; you’ll then see only the results for Nutshell Pram kits.
To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.
The Macomber 15 is a traditionally built flat bottom Westport River Skiff.
LOA: 15'2"
Beam: 5'11"
Draft: 6"
Max Hp: 25 (15Hp.recomended)
You think : I’d sure like to have a little harbor skiff to scoot around in the harbor/lake/river. And building a boat looks like fun, but I’ve never done it before; Not sure if I’m up to it.
“Breeze” is a 10′ (3m) double paddle canoe. Two sheets of plywood needed. Stitch and glue construction using 3″(75mm) fiberglass tape in epoxy for all seams inside and out. The deciding factors when designing the boat were mostly the same as with all my designs - seaworthiness and lightweight.
Good dories have a reputation for being difficult to design but easy to build. Iain Oughtred has taken care of the hard work here-you can’t go wrong with his detailed plans for this lapstrake (plywood) Swampscott derivative.Construction: Glued lapstrake plywood over sawn frames.Alternative constr
V-bottomed cruiser designed for plywood construction with accommodations for two and inside ballast.Construction: Plywood planking over sawn frames.Lofting is required.Plans include 11 sheets.Please note: gaff rig version’s mast measurements are taken by scaling from the plans.Notice the below de
S/V 14 designed by Simonis Voogd Design has been specifically created for sailors with disabilities. The E-book consists of 100 pages plan + videos, it is offered for free BUT, it must be for the benefit of the disabled community.
A perfect gift for the family's newest little boatbuilder, the CLC Cradle Boat is an ideal first stitch-and-glue project.
An easy-towing, easy-rowing tender featuring simple plywood construction and good capacity.
Construction: Plywood
No lofting is required
Plans include 3 sheets.
If we have to base ourselves on market demand before 2008, the two daysailers that we propose are very small. At that time, generally characterized by a continuous increase in boat size, it seemed as though a daysailer could not be less than 12 m, (even better if it exceeded 15 m).
Built in Denmark (1930s-40s ?) Eric Salander design. Restoration Project.
17' 9" glued lap strake sapele plywood with ribbon Sipo mahogany bright work.
Mahogany planked on oiled oak frames. Spruce spars and stainless rigging.
SUNDANCE II "Colonia" sailing dinghy designed in 1901 by Nathanael G. Herreshoff.