D'ANNA
D'ANNA is a 30' cold-molded evolution of the 29' Beals Island lobster boat, DIANA
If you’re in the market for a boat to build, this directory of Boat Plans & Kits is a fine place to start. And if your company sells plans or kits, we invite you to list your offerings here. There is no charge for listing, but the featured boats must be built of wood. To refine your search of this directory, use quotation marks. If you search Nutshell Pram Kit, you’ll receive all the listings that include the words Nutshell, Pram, and Kit. To refine your search, enter “Nutshell Pram Kit”; you’ll then see only the results for Nutshell Pram kits.
To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.
D'ANNA is a 30' cold-molded evolution of the 29' Beals Island lobster boat, DIANA
Round-bottomed, carvel-planked powerboat with two berths and a single 300-hp engine.
Construction: Carvel planked over steamed frames.
Alternative construction: Strip or cold-molded
Lofting is required.
Plans include 5 sheets.
Our pre-cut kits are cut by computer-guided routers to provide you with accurate parts. And, the kits come with just about everything needed except the elbow grease.The ladder frame—the “foundation” of the boat—is now included with the kit.
Designed by Joel White, the original boat was built plank-on-frame by Jimmy Steele (of Peapod fame), but no plans were ever drawn-until now.
A fast and able auxiliary cruiser with wheel steering and accommodations for three.
Construction: Carvel Planked over steamed frames.
Alternative construction: Cold-molded or strip.
Lofting is required.
Plans include 5 sheets.
The Chesapeake Bay is home to many wonderful work boats, one of the most unique is the tiny Smith Island Crab Skiff. Our team race boat the “Twisted Oyster”, built and raced by a consortium of three friends, has been very successful.
The New Ronan is a direct inspiration from our recently released Selkie design. When we came out with the Selkie we knew her sweeping lines would draw admiring stares, and we predicted petite paddlers would love that they finally had a boat designed specifically for them.
“Breeze” is a 10′ (3m) double paddle canoe. Two sheets of plywood needed. Stitch and glue construction using 3″(75mm) fiberglass tape in epoxy for all seams inside and out. The deciding factors when designing the boat were mostly the same as with all my designs - seaworthiness and lightweight.
The Skoota 28 is a 28 ft plywood demountable coastal cruising power catamaran for a couple. Ideal for the European canals, the PNW or the Great Loop. It will demount for transport on a flat bed lorry/truck or could even be towed by a large car but should not be considered “trailable”.
The Oxford Shell™ is a swift, smooth running "recreational" shell suitable for all skill levels. Whether you're just learning how to row a sliding seat shell, or you're a seasoned expert.
17' 9" glued lap strake sapele plywood with ribbon Sipo mahogany bright work.
Mahogany planked on oiled oak frames. Spruce spars and stainless rigging.
SUNDANCE II "Colonia" sailing dinghy designed in 1901 by Nathanael G. Herreshoff.
Restored in ME by Jonathan Minott (seen in WB "Launchings" July/Aug 2009).