Motorboats - Outboard

Kalostyn

Kalostyn was designed as the subject matter of a book that I had planned to write called, How to design a boat using SketchUp 3D software.I created a design that had lots of curves in order to demonstrate how to put these curved forms into a 3D model, and then create and export the the framing and flattened hull panels.I have yet to write that book!The design intent was for a hull that would perform reasonably well on low horsepower. I had about 15 hp in mind. The transom is designed to take a long shaft motor.

From the Community

Classified

Boat Launchings

Boat Launchings

PT 11

I built this PT 11 nesting dinghy from the CLC kit over this past winter, to replace a 9'6" Nutsh