Plans & Kits

FALCO singlehanded skiff

Didi 38 radius chine plywood cruiser/racer

Designed with extended wilderness paddlers in mind, her easy handling, good stability and low weight (only 60 lbs) make the Taiga an excellent choice for weekend and day excursions as well.

NWP XL is a very low drag touring kayak for paddlers weighing 180-250 pounds. Built from 4mm plywood in a garage, you can build two for the price of one kit with these plans. Weigh less? see NWP.

The Tolman Skiff has a Dory heritage with a “V” bottom and was designed to handle the inland and open waters of Alaska and is a very capable ocean skiff.

Virginia Park is an elegant lapstrake launch. Featured in WoodenBoat #234, Sept. – Oct. 2013, Virginia Park is built in the glued lapstrake method with steam bent frames.

Simon found an older version of this boat back in the eighties and realized that its thousand-year-old design could be copied and preserved without too much difficulty. He measured it out in ’89 and Bill Nielsen lofted it and drew up the plans in ’91.

Carvel-planked, outside ballasted cruiser with choice of three or four berths.

Construction: Carvel planked over steamed frames

Alternative construction: Cold-molded or strip

Sail Area : Sloop - 528 sq. ft., Yawl - 579 sq. ft.

Lofting is required.

Comprehensive details to allow you to construct a pair of the finest, strongest, and lightest (3.5 lbs each) hollow rowing oars to complement any wooden rowing boat.

24′ Chesapeake Bay Hampton FlattieL.O.A.: 24′ 2″L.W.L.: 22′ 8″Beam: 7′ 9″ Draft: 2′ ½″/3′ 9″Sail Area: 263 sq ftWeight: 2,500# (approx)Proportionately, this is the largest sharpie type known, and shows the maximum beam ratio successfully used in the sharpie type.