Plans & Kits

Outboard motor workboat for 8 to 30 hp Shallow draft, high capacity, simple build.

Open daysailer featuring plywood construction.

Construction: Lapstrake plywood over sawn frames

No lofting is required

Rig: Sliding Gunter

Plans include 35 sheets

4.80 m Plywood stitch & glue touring canoe. Only two plywood sheets are needed!

Oceangoing carvel-planked cruiser with a choice of centerboard or ballast keel configurations.

Construction: Carvel planked over sawn frames.

Alternative construction: Strip.

Lofting is required.

Plans include 7 sheets.

16ft Plywood stitch & glue touring canoe.

Athelas is a 17'-2" open water recreational rower for one or two based on a lines sketch by N. G. Herreshoff. Built from 6 and 9 mm glued lapstrake plywood, she weighs 81 pounds and can be cartopped

The Sponge Docks Skiffs are designed for first-time builders, due to their simple stitch and glue assembly, yet on the water these good looking boats are versatile, stable and dry.The SDS19 is the latest in the series, and includes:

• Removable sole panels simplify construction.

Sharpie 31.5′ EGRETL.O.A.: 31′ 6 ½″SPARRED LENGTH: 35′ 6″L.W.L.: 26′ 3″BEAM: 8′ 6″DRAFT: 1′ 2 ¼″ /4′ 8″SAIL AREA : (Depends on rig)DISP.: 5,000# (approximate, for cruising)BALLAST: 1,500 lbs. lead, inside; additional to trim as needed.

Kalostyn was designed as the subject matter of a book that I had planned to write called, How to design a boat using SketchUp 3D software.I created a design that had lots of curves in order to demonstrate how to put these curved forms into a 3D model, and then create and export the the f

A small and very simple tender to fit inside a station wagon or on a roofrack, this little plywood dink will suit some one wanting a tender for their small yacht or motorboat.