If you’re in the market for a boat to build, this directory of Boat Plans & Kits is a fine place to start. And if your company sells plans or kits, we invite you to list your offerings here. There is no charge for listing, but the FEATURED BOATS MUST BE BUILT OF WOOD.
To refine your search of this directory, use quotation marks. If you search Nutshell Pram Kit, you’ll receive all the listings that include the words Nutshell, Pram, and Kit. To refine your search, enter “Nutshell Pram Kit”; you’ll then see only the results for Nutshell Pram kits.
To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.
the Mark V 20 is a trailereble outboard powered cruiser.
The project, despite its small size, develops a discrete internal volume allowing to nr. 4 crew members to spend short cruises with good speed and pleasant navigation.The hull lines and the deck are to corner for simplicity of construction, and are harmonized with the hull volume.
The Solo Packette is designed for those searching for pack canoe that they can carry to even through the most difficult approaches.
Traditional "Whitehall" elegance in a stitch-and-glue kit. For casual single and tandem rowing, we do not believe there is a better build-your-own-boat kit than the Chester Yawl.
Prospector “Ranger” 15 — a pocket-sized prospector.The Prospector models built by the Chestnut Canoe Company were made in lengths from 12 to 18 ft.
A trim, rugged, carvel-planked cruiser with simple accommodations for two and a choice of gaff or marconi rig.Construction: Carvel planked over steamed framesAlternative construction: Cold-molded or strip Lofting is requiredPlans include 7 sheets
The PT 11 is a very versatile boat. It rows, sails, and motors and it does all those things exceptionally well. It also nests for carrying on the deck of your sailboat or in the back of a vehicle.
Spring Lake Small Craft can provide a very complete CNC routed kit for the Pippie 8 tender. Designed by Mike Waller (http://www.wallerdesign.com.au) to be used as a very versatile tender.
Designed by: John G. Alden (Naval Architect). Alden Design No.
Ocoume plywood, fiberglassed and epoxied throughout, finished with spar varnish and Interlux Brig
