If you’re in the market for a boat to build, this directory of Boat Plans & Kits is a fine place to start. And if your company sells plans or kits, we invite you to list your offerings here.
There is no charge for listing, but the FEATURED BOATS MUST BE BUILT OF WOOD.
To refine your search of this directory, use quotation marks. If you search Nutshell Pram Kit, you’ll receive all the listings that include the words Nutshell, Pram, and Kit. To refine your search, enter “Nutshell Pram Kit”; you’ll then see only the results for Nutshell Pram kits.
To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.
Seaworthy, stable, and easily rowed. Here is a pod that is a bit smaller than most, but she will still carry a big load and bring you through some lumpy water with confidence.
Swansea Pilot Schooner, flush-decked cruiser, based on the earliest type (late 18th/early 19th century). This vessel is intended for open ocean cruising.
The CS23 is an offshore boat based on the Carolina Sport Fishing boats lines.
Concept: The CCSF25 is a high performance offshore fishing and family boat, she has a classic running surface of 24 degree deadrise and 8.5' max beam. Wide chine flats for knocking down spray, integrated lifting strakes for high speed handling and directional control.
The Duo is a simple to build 3m (10ft) hard chine rowing and sailing dinghy that can be built from just two sheets of 4mm (3/16in) plywood. It is also available as a nesting dinghy, so it can be stored on a cabin roof or even in the back of a car.
Sharpie 31.5′ EGRETL.O.A.: 31′ 6 ½″SPARRED LENGTH: 35′ 6″L.W.L.: 26′ 3″BEAM: 8′ 6″DRAFT: 1′ 2 ¼″ /4′ 8″SAIL AREA : (Depends on rig)DISP.: 5,000# (approximate, for cruising)BALLAST: 1,500 lbs. lead, inside; additional to trim as needed.
Rugged little launch with generous beam.
Construction features a traditional backbone of bolted-up oak, steam-bent frames and strip-planking. Four different arrangements are shown.
Construction: Strip-planked over steam-bent frames.
25′ LOA carvel-planked daysailer with small cabin. Construction: Carvel planked over steamed frames. Alternative construction: Cold-molded or strip. Lofting is required. Plans include 4 sheets.
Spray 33
Wood / Epoxy This 33ft Spray has been built in large numbers and has crossed all oceans and completed circumnavigations.
“Breeze” is a 10′ (3m) double paddle canoe. Two sheets of plywood needed. Stitch and glue construction using 3″(75mm) fiberglass tape in epoxy for all seams inside and out. The deciding factors when designing the boat were mostly the same as with all my designs - seaworthiness and lightweight.
Sweet-lined Acorn skiff designed by Iain Oughtred, completed in 1999 but still like new.
SOLD MAY 2026
NO MORE INQUIRIES
Rocklady, Sam Devlin design for builder/owner John Calogero, Sr.
Fiberglass bottom, trailer. Built in 2005 by Old Wharf Dory Company in Wellfleet, MA.
