If you’re in the market for a boat to build, this directory of Boat Plans & Kits is a fine place to start. And if your company sells plans or kits, we invite you to list your offerings here. There is no charge for listing, but the FEATURED BOATS MUST BE BUILT OF WOOD.
To refine your search of this directory, use quotation marks. If you search Nutshell Pram Kit, you’ll receive all the listings that include the words Nutshell, Pram, and Kit. To refine your search, enter “Nutshell Pram Kit”; you’ll then see only the results for Nutshell Pram kits.
To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.
As featured in WoodenBoat issue #274, the Tombolo 28 is an iconic modern classic outboard-powered cruiser. The mission of the design dictates a maximum length under 30′ and a trailerable beam.
20' LOA carvel-planked open daysailer. Construction: Carvel planked over steamed frames. Alternative construction: Cold-molded or strip. Lofting is required. Plans include 4 sheets, and suggested for experienced builders only as the plans info is sparse.
The i550 is a very popular 18 foot stitch and glue design. Simple construction and avid builder blogs and websites add a sense of community and support for the builder.
The Crystal 16 was designed to be a simple, lightweight flats skiff. Her hull is a simple V-bottom with a bit of flare in her topsides. Her deck features a large casting platform forward with two smaller platforms back aft on both sides. Storage is available up forward below the casting deck.
This design was inspired by Ross Lillistone’s “Water Rat”. The bow transom was replaced by a pointed stem. Also the internal volume and from there the displacement of the boat were increased by about 20%. Changes were made to the seating arrangement as well.
V-bottomed seaworthy pocket daysailer/cruiser designed for plywood construction...
Rugged little launch with generous beam.
Construction features a traditional backbone of bolted-up oak, steam-bent frames and strip-planking. Four different arrangements are shown.
Construction: Strip-planked over steam-bent frames.
The Skoota 28 is a 28 ft plywood demountable coastal cruising power catamaran for a couple. Ideal for the European canals, the PNW or the Great Loop. It will demount for transport on a flat bed lorry/truck or could even be towed by a large car but should not be considered “trailable”.
As much functional sculpture as sea kayak, the Arctic Hawk™ could be the most refined stitch-and-glue watercraft anywhere in the world.
If we have to base ourselves on market demand before 2008, the two daysailers that we propose are very small. At that time, generally characterized by a continuous increase in boat size, it seemed as though a daysailer could not be less than 12 m, (even better if it exceeded 15 m).
Length: 18 feet, Beam: 8.25 feet, draft: about 1 foot.
21’ long, 16’ beam (reduces to 8'5" for trailering), strip plank construction, 850lbs with all ge
I built this PT 11 nesting dinghy from the CLC kit over this past winter, to replace a 9'6" Nutsh
