September / October 2020

Building a Midget Flyer Runabout Part 2

Little boat, big fun
Midget Flyer Runabout

In part 1 of this series, which appeared in the previous issue (WB No. 275), we assembled the frames and backbone of this little Flyer, set them up, and installed the chines and battens. Here, we install the hull and after deck planking.

Step 12—Make plank patterns

To make patterns for the bottom planks, first mark the centerline of each batten down the full length of the hull. The planks should be symmetrical, so, theoretically, you could make patterns for one side of the boat and reverse them for the other side. It is good practice, however, to pattern each plank just in case of discrepencies.

Purchase this issue from WoodenBoat Store

From This Issue

Issue No. 276
EMPRESS OF BLANDINGS

First Light Boatworks of Chatham, Massachusetts, began operating in the same

Issue No. 276
Beetle Cats

Like a down-turned thumb, the Massachusetts peninsula known as Clarks Point

Issue No. 276
Chine Seams

When building a V-bottomed hull, it can be difficult to mate the edges of the

Issue No. 276
KATABATIC

The Marlborough Sounds region encompasses a series of sparsely populated

From the Community

Classified