Plans & Kits

9 foot wooden catamaran

Round-bottomed pocket cruiser with room for an inboard auxiliary and accommodations for two.

Construction: Carvel planked over steamed frames.

Alternative construction: Cold-molded or strip

Lofting is required.

Plans include 11 sheets.

The Noank Pulling Boat is an 18′ x 36″ [5.5m x 91cm] sliding seat rowing boat suitable for open water travel.

Athey is a 15' open water recreational rower for one or two based on a lines sketch by N. G. Herreshoff. Built from 4, 6 and 9mm glued lapstrake plywood, she weighs just 65 pounds and is cartopped.

The LINNET is a seaworthy rowing boat that has been specifically designed for sea use. Accordingly it does not have outriggers or a sliding seat while a small daggerboard is fitted to help prevent being blown sideways by the wind. A good load carrier, LINNET can be rowed by 1-3 people.

The i550 is a very popular 18 foot stitch and glue design. Simple construction and avid builder blogs and websites add a sense of community and support for the builder.

Seaworthy, stable, and easily rowed. Here is a pod that is a bit smaller than most, but she will still carry a big load and bring you through some lumpy water with confidence.

Stitch & Glue Night Heron is at home out on the open water and exploring the shores of distant islands.

Very simple workboat for outboard motor power. Suits 8 to 30 hp motors,carry up to six persons, can be built longer or shorter as required.

The Puur 17 is a trailerable performance daysailer that’s been featured in Small Craft Advisor. The modern design is unsinkable, self-righting from knock-down, easy to solo, and comfortable for 2 adults with 2 kids.