18' 7" Utility Launch, BARBARA ANNE
Rugged carvel construction, round bottomed. Driven by a small inboard. Construction: Carvel planked over steamed frames. Alternative construction: Cold-molded, Strip. Lofting is required. Plans include 3 sheets.
If you’re in the market for a boat to build, this directory of Boat Plans & Kits is a fine place to start. And if your company sells plans or kits, we invite you to list your offerings here. There is no charge for listing, but the featured boats must be built of wood. To refine your search of this directory, use quotation marks. If you search Nutshell Pram Kit, you’ll receive all the listings that include the words Nutshell, Pram, and Kit. To refine your search, enter “Nutshell Pram Kit”; you’ll then see only the results for Nutshell Pram kits.
To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.
Rugged carvel construction, round bottomed. Driven by a small inboard. Construction: Carvel planked over steamed frames. Alternative construction: Cold-molded, Strip. Lofting is required. Plans include 3 sheets.
This cozy pocket cruiser combines simple sheet-plywood construction with more than a touch of elegance.Her board-up draft of 1′6″ lets you explore secluded coves and is easy to haul with a trailer.Construction: Plywood planking over sawn frames.Lofting is required.Plans include 6 sheets.
Easy to Build Flat Bottom Skiff 18 ft Instructions also Include Our 14 Ft Smaller Version
The TRICKY FIVE has been conceived for a precise scope: to realize a boat, which in relation to its size would maximize the ratio between speed and cost. This means that for a determined cost for materials and hours of construction required, it would be the fastest possible.
Tandem Row & Sail | CartoppableSpecifications:
The Noank Pulling Boat is an 18′ x 36″ [5.5m x 91cm] sliding seat rowing boat suitable for open water travel.
These handsome, practical row boats were routinely built by Nova Scotia shipwright, Jim Smith in six days, painted and ready for the water.
Simon found an older version of this boat back in the eighties and realized that its thousand-year-old design could be copied and preserved without too much difficulty. He measured it out in ’89 and Bill Nielsen lofted it and drew up the plans in ’91.
Complete with spars and sails. Lying Cape Cod. Last restored c1970. Cockpit and deck are newer.
Lord Nelson Royal Navy 1798 pattern Pinnace. Pine on oak. Length 28.5 feet. Needs few repairs.