If you’re in the market for a boat to build, this directory of Boat Plans & Kits is a fine place to start. And if your company sells plans or kits, we invite you to list your offerings here.
There is no charge for listing, but the FEATURED BOATS MUST BE BUILT OF WOOD.
To refine your search of this directory, use quotation marks. If you search Nutshell Pram Kit, you’ll receive all the listings that include the words Nutshell, Pram, and Kit. To refine your search, enter “Nutshell Pram Kit”; you’ll then see only the results for Nutshell Pram kits.
To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.
The Mark V 39 is an outboard powered Sharpie houseboat.
Safe, seaworthy, shoal-draft double-ender, with a flat bottom and centerboard. Lofting is required. Plans include 4 sheets.
A deep-V bottomed, open runabout built of plywood over sawn frames.
Construction: Plywood planking over sawn frames
Lofting is required.
Plans include 5 sheets.
The Crystal 16 was designed to be a simple, lightweight flats skiff. Her hull is a simple V-bottom with a bit of flare in her topsides. Her deck features a large casting platform forward with two smaller platforms back aft on both sides. Storage is available up forward below the casting deck.
Spring Lake Small Craft can provide a very complete CNC routed kit for the Pippie 8 tender. Designed by Mike Waller (http://www.wallerdesign.com.au) to be used as a very versatile tender.
‘Volare’ comes in two versions. This is the utility version, the console version is available as a separate set of plans. They’re both 15′4″ long and 5′ wide.Her length is that of two sheets of 8′ plywood and she’s built in two halves (bow end and stern end).
SAM is a pure racing boat built in composite with the sandwich technique. A prototype of this boat got a good result in World Championship of the class same years ago.
Cutter designed by John Hyslop in 1876. An early combination of English and American ideas, PETREL was designed according to the wave form theory.You’ll receive 2 pages of plans historical information about the boat and step-by-step instructions for half-hull building,using the lift method.The pl
“Breeze” is a 10′ (3m) double paddle canoe. Two sheets of plywood needed. Stitch and glue construction using 3″(75mm) fiberglass tape in epoxy for all seams inside and out. The deciding factors when designing the boat were mostly the same as with all my designs - seaworthiness and lightweight.
For cold-molded construction, a rugged cutter, popular with serious cruisers.
Construction: Cold-molded.
Alternative construction: Carvel, strip.
Lofting is required.
Plans include 11 sheets.
Built by professional Vermont furniture maker. In exceptional condition.
This Venetian Gondola (K208) by Wooden Boat USA (2025) captures the elegance of traditional Venet
This is the launch of my cutter based a design by C P Kunhardt from 1885.
