Oar / Paddle
The Open Boat
This is a design for a basic hull made from one piece of closed cell foam 1m x 4m x 50mm thick.
If you’re in the market for a boat to build, this directory of Boat Plans & Kits is a fine place to start. And if your company sells plans or kits, we invite you to list your offerings here. There is no charge for listing, but the featured boats must be built of wood. To refine your search of this directory, use quotation marks. If you search Nutshell Pram Kit, you’ll receive all the listings that include the words Nutshell, Pram, and Kit. To refine your search, enter “Nutshell Pram Kit”; you’ll then see only the results for Nutshell Pram kits.
To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.
This is a design for a basic hull made from one piece of closed cell foam 1m x 4m x 50mm thick.
A stitch and glue touring canoe design 14' x 30" [4.3 m x .76 m]
The CS23 is an offshore boat based on the Carolina Sport Fishing boats lines.
Miniature voyaging and cruising yacht for amateur boatbuilders, can carry two, capable of short blue water voyages.
This charming addition to our cradle boat fleet is adapted from a type known as a pram. Prams have transoms at both bow and stern, and are used extensively as tenders for larger vessels because of their roominess in a relatively short length.
An outboard skiff with a wide bottom and moderate rocker that contribute to stability and the ability to carry weight back aft.
Construction: Cross-planked bottom, lapstrake sides
Alternative construction: Plywood or glued-lapstrake plywood
Lofting is required
The design of Sportfish 570 comes from a collaboration with a Senegalese society, with the aim of creating fishing vessels for inland waters of modern conception.
“Trixie” began as an idea for a small and simple to build plywood tender, able to get out to a mooring with two or three on board, that was very light, incorporated wheels to enable transport to the slipway, was designed to provide the maximum space from two sheets of 1/4″ plywood, and could be p
A deep-V bottomed, open runabout built of plywood over sawn frames.
Construction: Plywood planking over sawn frames
Lofting is required.
Plans include 5 sheets.
Build the Babson 14 from scratch! Plans include three variations on the hull: sheet ply (like our kits), glue-lap-ply, power, suitable for up to a 2 horsepower outboard.Plans contain 16 sheets of drawings, full-sized mold patterns so no lofting is required (no offsets are included with the plans)
“CHARM” is an 85′ LOA schooner originally designed to be a personal yacht that was built and fini
Built in 1933 as a commercial NC “sink netter”, “Sylvia II” has been totally restored and rebuilt
William Shaw design, 24' Yawl with shoal keel and centerboard, built 1958 in Denmark.